Get answers to common questions about SC Johnson Professional products.
Deep Penetrating Floor Stripper – Step 1

Recommended for:
- Vinyl composition tile, vinyl asphalt tile, vinyl asbestos tile.
- Terrazzo
- Sealed Concrete
Not Recommended for:
- Marble, Wood floors, Linoleum, Decorative Concrete
- Protect carpet and other surfaces from coming in contact with stripper.


- No, this product is for Commercial Use Only.


- For best results, dust mop the floor prior to applying the
Stripper.




- Light buildup of finish - 1 part stripper to 8 parts cool
water.
- Heavy buildup of finish - 1 part stripper to 4 parts cool
water.


- For best results the stripper should sit for 5 to 10 minutes.
- Longer contact time may be required for heavy buildup.
- Longer contact times will not harm your floor.
- Do not allow stripper to dry.


- Blockade area to be stripped. Place Blockade signs. (Floor will become
very slippery when wet)
- Use in a well ventilated area.
- Wear chemical splash guard goggles, chemical resistant gloves, and
protective footwear.


- No, you should never mix this product with other cleaners or
chemicals.


- PH = 13.16 (concentrated)


- Keep unused stripper in a tightly closed container and in a cool dry
place.
- Follow MSDS sheets for proper disposal.
- Follow all state and federal disposal guidelines.


- 1 gallon = 500 to 1000 square feet when applied following the label
directions.


- SC Johnson Floor Stripper has been specially formulated to require no rinsing or neutralizing. For best results SC Johnson does recommend this optional step to ensure good bonding of the finish coat.
Multi-Surface Floor Sealer – Step 2

Recommended for:
- Recommended for floors where adhesion is an issue.
- Vinyl composition tile, vinyl asphalt tile, vinyl asbestos tile.
- Terrazzo
- Sealed Concrete
Not Recommended for:
- Marble
- Wood floors
- Linoleum
- Decorative Concrete
- Protect carpet and other surfaces from coming in contact with sealer.


- No, this product is for Commercial Use Only.


- For best results use a finish mop. i.e. rayon, nylon, or synthetic string mop.
- Do not use a cotton or sponge mop as they may leave lint particles that will be noticeable when the floor dries.


- Highly recommended for floors where adhesion is an issue such as laminate floors with PVC coatings.
- It is recommended to seal the surface first for terrazzo, sealed concrete.
- It is optional to seal the surface first for vinyl, ceramic, slate, and stone floors.


- Blockade area to be sealed. Place Blockade signs. (Floor will become very slippery when wet)
- Use in a well ventilated area.


- No, you should never mix this product with other cleaners or chemicals.




- Keep unused sealer in a tightly closed container and in a cool dry place.
- Follow MSDS sheets for proper disposal.
- Follow all state and federal disposal guidelines.


- Product exposed to freezing temperature will separate and should not be used.


- 1 gallon = 2000 to 2500 square feet per coat when applied following the label directions.
- 2.5 gallon = 5000 to 6250 square feet per coat when applied following the label directions.
High Gloss Floor Finish – Step 3

Recommended for:
- Vinyl composition tile, vinyl asphalt tile, vinyl asbestos tile.
- Terrazzo
- Sealed Concrete
Not Recommended for:
- Marble
- Wood floors
- Linoleum
- Decorative Concrete
- Protect carpet and other surfaces from coming in contact with finish.


- No, this product is for Commercial Use Only.


- For best results us a rayon, nylon, or synthetic string mop.
- Do not use a cotton or sponge mop as they may leave lint particles that will be noticeable when the floor dries.


- Highly recommended for floors where adhesion is an issue.
- It is recommended to seal the surface first for terrazzo, and sealed concrete floors.
- It is optional to seal the surface first for vinyl, ceramic, slate, and stone floors.


- Blockade area to be sealed. Place Blockade signs. (Floor will become very slippery when wet)
- Use in a well ventilated area.


- No, you should never mix this product with other cleaners or chemicals.




- Keep unused finish in a tightly closed container and in a cool dry place.
- Follow MSDS sheets for proper disposal.
- Follow all state and federal disposal guidelines.


- Product exposed to freezing temperature will separate and should not be used.


- 1 gallon = 2000 to 3000 square feet per coat when applied following the label directions.
- 2.5 gallon = 5000 to 7500 square feet per coat when applied following the label directions.


- Allow approximately 30 – 45 minutes to dry to the touch.
- Allow 90 minutes for traffic.
High Traffic Floor Finish – Step 3

Recommended for:
- Vinyl composition tile, vinyl asphalt tile, vinyl asbestos tile.
- Terrazzo
- Sealed Concrete
Not Recommended for:
- Marble
- Wood floors
- Linoleum
- Decorative Concrete
- Protect carpet and other surfaces from coming in contact with finish.


- No, this product is for Commercial Use Only.


- For best results us a rayon, nylon, or synthetic string mop.
- Do not use a cotton or sponge mop as they may leave lint particles that will be noticeable when the floor dries.


- Highly recommended for floors where adhesion is an issue.
- It is recommended to seal the surface first for terrazzo, sealed concrete floors.
- It is optional to seal the surface first for vinyl, ceramic, slate, and stone floors.


- Blockade area to be sealed. Place Blockade signs. (Floor will become very slippery when wet)
- Use in a well ventilated area.


- No, you should never mix this product with other cleaners or chemicals.




- Keep unused finish in a tightly closed container and in a cool dry place.
- Follow MSDS sheets for proper disposal.
- Follow all state and federal disposal guidelines.


- Product exposed to freezing temperature will separate and should not be used.


- 1 gallon = 2000 to 2500 square feet per coat when applied following the label directions.
- 2.5 gallon = 5000 to 6250 square feet per coat when applied following the label directions.


- Allow approximately 30 – 45 minutes to dry to the touch.
- Allow 90 minutes for traffic.
Calcium, Lime & Rust Remover

- SC Johnson Professional™ Calcium, Lime & Rust Remover is an acid-based non-abrasive cleaner that removes tough calcium, lime, rust and other stains caused by water.


- This product can be used on most porcelain, ceramic tile, glass, fiberglass, cement, stucco and stainless steel surfaces.




- Yes. Always be sure to rinse food-preparation surfaces with potable (clean, drinkable water) after use.


- No. We don’t recommend transferring this product to any other container.


- Yes, when used according to label directions.


- No. This product is NOT registered with the EPA as a disinfectant or sanitizer.


- Dispose of any unused product according to all federal, state and local applicable regulations. Refer to MSDS, which can be found at our website scjohnson-professional.com.


- SC Johnson Professional™ Calcium, Lime & Rust Remover can be found at hardware and DIY stores such as Home Depot and Menards.
Heavy Duty Degreaser

- SC Johnson Professional™ Heavy Duty Degreaser is a ready to use cleaner that removes tough grease, petroleum, and food oils from hard, water-washable surfaces.


- SC Johnson Professional™ Heavy Duty Degreaser can be used on water-washable surfaces such as counter tops, chrome, plastics, walls and stainless steel.




- Yes, we do not recommend using this product on aluminum, glass and water- based paints.


- No. Never mix this product with other cleaners or chemicals.


- No, when used according to label directions, this product will not harm septic systems.


- Dispose of any unused product according to all federal, state and local applicable regulations. Refer to MSDS.


- SC Johnson Professional™ Heavy Duty Degreaser can be found at hardware and DIY stores such as Home Depot and Menards.
All-Purpose Neutral Cleaner Concentrate

- When properly mixed with water, SC Johnson Professional™ All-Purpose Neutral Cleaner Concentrate provides users with a cost-effective cleaner ideal for daily or frequent cleaning of hard surfaces. See Concentrate label for proper dilution instructions.


- This product is recommended for commercial (business) use. With careful attention to product instructions, the All-Purpose Cleaner provides an effective and economical solution for residential projects.


- When diluted with water (1:32 ratio) the pH is 8.1.


- This product can be used on most hard surfaces including walls, floors, countertops, and more. In addition, this product can be used in automatic floor scrubbing machines.


- Yes, when properly diluted with water, this product is ideal for vinyl composition tile, vinyl asphalt tile, vinyl asbestos tile, terrazzo, and sealed concrete using a cotton mop or automatic scrubbing machine. Do not use on marble, wood floors, linoleum, or decorative concrete.


- Both the Concentrate bottle and high performance, wide-mouth Sprayer have specific markings to help the user properly dilute the cleaner for the specific task. In addition, the Sprayer meets OSHA requirements for a properly labeled spray bottle reducing user error and insuring safe usage.


- Dispose of any unused product according to all federal, state, and local applicable regulations. Refer to MSDS.


- These products are available at various retailers that support and service commercial cleaners.
Heavy-Duty Degreaser Concentrate

- When properly mixed with water, SC Johnson Professional™ Heavy-Duty Degreaser provides users with a cost-effective, powerful alkaline formulation cleaner ideal for removing tough grease, petroleum, and food soils from hard, water-washable surfaces. See back label of Concentrate for proper dilution instructions.


- This product is recommended for commercial (business) use. With careful attention to product instructions, the Heavy-Duty Degreaser provides an effective and economical solution for residential projects.


- When diluted with water (1:16 ratio) 10.8


- Once properly mixed with water according to product instructions, this product can be used on water-washable surfaces such as counter tops, chrome, plastics, walls, and stainless steel.


- Yes, we do not recommend using this product on aluminum, glass, and water-based paints.


- Both the Concentrate bottle and high performance, wide-mouth Sprayer have specific markings to help the user properly dilute the cleaner for the specific task. In addition, the Sprayer meets OSHA requirements for a properly labeled spray bottle reducing user error and insuring safe usage.


- Dispose of any unused product according to all federal, state, and local applicable regulations. Refer to MSDS.


- These products are available at various retailers that support and service commercial cleaners.
Glass Cleaner Concentrate

- When properly mixed with water, SC Johnson Professional™ Glass Cleaner Concentrate provides users with a cost-effective cleaner ideal for daily or frequent cleaning of hard surfaces. See back label of Concentrate for proper dilution instructions.


- This product is recommended for commercial (business) use. With careful attention to product instructions, the Glass Cleaner provides an effective and economical solution for residential projects.


- When diluted with water (1:16 ratio) the pH is 8.2.


- This product will provide a streak-free shine on glass, mirrors, chrome, vinyl, plastic tile, and more.


- Both the Concentrate bottle and high performance, wide-mouth Sprayer have specific markings to help the user properly dilute the cleaner for the specific task. In addition, the Sprayer meets OSHA requirements for a properly labeled spray bottle reducing user error and insuring safe usage.


- Dispose of any unused product according to all federal, state, and local applicable regulations. Refer to MSDS.


- These products are available at various retailers that support and service commercial cleaners.